Circuit Schematic DC Motor Driver PWM H-Bridge using MOSFET

Eltronicschool. - There are many circuit schematic designed using MOSFET component for many application. One application is to build DC motor driver H-Bridge. In here we will give you specific Circuit Schematic DC Motor Driver PWM H-Bridge using MOSFET like in Figure 1 below. (You also can read: Circuit Schematic 12V LDO Solar Charge Controller using MOSFET)

Circuit schematic

Figure 1. Circuit Schematic DC Motor Driver PWM H-Bridge using MOSFET (Source: Corelita.com)

Component Parts

1. IC 7555
2. IC TC4469
3. MOSFET
4. Resistors
5. Capactors
6. Diode

Description

Circuit schematic like in Figure 1 above is Circuit Schematic DC Motor Driver PWM H-Bridge using MOSFET. According Carolita site describe that Scheme DC PWM motor driver circuit H-Bridge is used for DC motor driver dngn great power. Scheme DC motor driver circuit is put on bridge system which was built dngn 4 pieces MOSFET which derive from the driver IC TC4469. Scheme DC motor driver circuit is wearing a PWM system Dlm set rotation speed of a DC motor and wear TTL logic (HIGH and LOW) to control the direction of rotation of DC motors.

Scheme series DC motor driver IC 7555 over wearing the fancy set dngn as astable multivibrator pulse width can be set as pulse dngn purpose PWM driver for DC motor driver dngn 4 H-Bridge MOSFET unit.

The parts that are on the DC motor driver PWM MOSFET H-bridge dngn above could describe as below.

1. Pulse generator, the side in the wake dngn IC 7555 which acts as a PWM pulse generator. PWM pulse width of the circuit scheme could be set with variable resistor / barriers with VR size 100KOhm.
2. Controlling the direction of the play, the circuit schematic wear digital gate circuit scheme IC TC4469 principles which act as control the direction of rotary motors DC.
3. DC motor driver, the side build using bridge which are arranged with 4 pieces MOSFET controller as a DC motor rotation speed and direction of rotation of DC motors.
4. Scheme DC motor driver circuit H-bridge PWM is working using voltage / voltage source of + 12 volts DC fitted with voltage / working voltage DC motor in use.