Eltronicschool. - There are many circuit schematic designed for battery charger. One application battery charger circuit schematic is Circuit Schematic Ni-MH Battery Charger using LT4060 like in Figure 1 below. (You also can read: Circuit Schematic 12V LDO Solar Charge Controller using MOSFET)
Circuit schematic
Component Parts
- NTC Thermistor
- Resistors
- LT4060 IC
- LED
- Variable Resistor
- Capacitor
- Recharge Battery, Ni-MH
- Transistor MJD210
Description
Circuit schematic like in Figure 1 above is Circuit Schematic Ni-MH Battery Charger using LT4060. According Circuitstoday site describe that This is the circuit diagram of a very powerful and efficient Ni-MH battery charger using IC LT4060 from Linear Technologies. In addition to Ni-MH batteries Ni-Cd batteries can be also charged by slightly modifying the circuit.For charging Ni-Cd batteries connect the CHEM pin (pin12) of the IC to +Vcc.Here the circuit is configured to charge 2 cells connected in series. By altering the connections of SEL0 and SEL1 pins, upto 4 batteries in series can be charged using this circuit. For charging a single cell, connect SEL0 and SEL1 pins to GND. For charging two cells, connect SEL1 to GND and SEL0 to Vcc. For charging three cells, connect SEL1 to VCC and SEL0 to GND. For charging 4 cells, connect SEL0 and SEL1 pins to VCC. The circuit also features temperature based charge qualification.An NTC thermistor connected at the NTC pin (pin11) of the IC serves as the temperature sensor.
For more information about Circuit Schematic Ni-MH Battery Charger using LT4060 you can read more it from original source using this [Link]
For more information about Circuit Schematic Ni-MH Battery Charger using LT4060 you can read more it from original source using this [Link]
0 comments:
Post a Comment
Thank's for your reading in this article, please don't forget to comment.